NOGUCHI SOUBI Co.,Ltd.
921-2 Oyana Seki-City Gifu Pref.
TEL +81 575 28 2057
Read carefully before use
Water-shedding property of Filter Material
MS filter is made of non-woven polypropylene due to its filtration capacity and durability.
This material is mildly water-repellent.
When setting a new filter, cutting fluid may accumulate on the filter due to its characteristics.
(It is normal.)
In this case, lightly impact the filter with the accumulated liquid.
Lightly tap the cutting fluid holding section, or pinch the edge of the filter and let it fall.
After the cutting fluid starts flowing out, the filter will run continuously while maintaining a normal flow rate of cutting fluid.
If the flow rate decreases due to clogging, it is time to replace the filter and replace it with a new one.
|MS70 20micron Type
|MS80 10micron Tipe
|MS100 5micron Type
|MS71 20micron Type
|MS81 10micron Type
|MS101 5micron Type
|MS40 40micron Type
Material Polypropylene non-woven fabric
Quality Tested by JIS method
Feature New partitions catch more debris in a larger area.
Filtration performance is 10-30% higher than conventional products.
The large permeable area allows the cutting fluid to be retained in the filter for a shorter period of time.
The melting point is lower than that of polyester, so the furnace is not damaged during incineration.
No toxic gas is generated during incineration.
Dries quickly because it does not absorb water or moisture.
We can accept your special order.
Manufacturer Genuine parts of Okuma Co., Ltd
Thank you for inquiring about MS Filter.
The estimate for MS-Filter is as follows.
However, we cannot supply less than 100 units.
Therefore, we have quoted the minimum quantity.
- MINIMUM Q’TY OF SHIPMENT
100 filters as above of each quantity
2pcs of MS Filter in a zipper poly bag.
2pcs x50pack=100pcs/Carton box.
Size of carton box:800 x 300 x200mm 8 to 10Kg /100pcs
Please refer to the price.